Wall Decorating Ideas



The first involves finishing off apart-riled wall with a band of narrow tiles in a colour or design that complements or contrasts with the main riled area, to form a decorative border. These tiles are available in lengths that match standard rile widths, and are usually 50-75 minimum 2-3 in wide. They are cur and fixed just like any other tile.

The second method is to incorporate a group of patterned tiles as a feature panel within a larger area of plain riling. The group may simply be contrasting patterned tiles, or may be a multi-tile motif a group of four, six or more tiles that fit together to form one large design when they are fixed in position. Tile manufacturers offer a range of mass-produced designs you can choose from, or a motif panel can he commissioned from a specialist tile supplier. Plan the motif’s position on the wall carefully, and build it in the usual way as tiling progresses.



I. Use a tiling gauge to mark the position of the first row of tiles on the wall surface. Put up a support batten (furring strip) if necessary then spread some tile adhesive on the wall, and place any plain tiles that will be below the decorative panel. Start placing the first tiles that will form the decorative panel. Here the tiles are being laid at an angle of 45°, so half-tiles are placed first.

2 .Continuous adding whole and half-tiles to build up the pattern, checking is you work that the edges of the panel are uniformly horizontal and vertical.



3. Here the panel is being surrounded by slim border tiles. Add whole border riles to the top of the panel first, working from the centre line outwards.

4. At the corners of the panel, fit an over-long horizontal border tile and hold another vertically over it so you can mark a 45° cutting line on each tile.



5. Make the 45° cuts on the end of each corner tile, then bed the horizontal tile in place. Check that the CUE end is precisely aligned with the panel comer. Repeat the process at the other end of the horizontal section of the border. The pieces should be the same length, as the border is centred.

6. Fit the border riles up each side of the decorative panel, then mark the position of the mitre cut on the final tiles, cut them and fit them in place.